Konfigurieren von Rechnern und Anwendungsprogrammen ::Stand: 28.06.2004
	Impressum :: Feedback :: Forum :: Newsletter ::
Pfad ::: Home / Netzwerkadministration / Netzwerke - Fragen und Antworten

1.4.   Netzwerke - Fragen und Antworten

1.4.1.  Serverdienste und Teilnetzwerke (Subnets)

1. Situation

Your routed TCP/IP network consists of 3 Windows 2000 Server computers and 82 Windows 2000
Professional computers. Your network uses TCP/IP as the only network protocol. You are installing 18
new Windows XP Professional computers. You want to enable the new computers to use NetBIOS
names to connect to all shared resources as the network. You configure a TCP/IP address and a subnet
mask on each new computer.

Which 2 additional TCP/IP properties should you configure on each new computer? (Choose two)

a. DHCP server address
b. WINS server address
c. DNS address
d. Physical address (MAC)
e. Gateway address.


Please translate into german before solving the situation :-)

Answer: ?, ?
Explanation:... to be continued ...

 

2. Situation

You install Windows 2000 Professional on a computer named client 2. Client 2 is configured to have a
TCP/IP address of 10.10.167.4 and a default gateway of 10.10.167.1.
The network is configured as shown in the exhibit.

You want to connect to a shared folder on server B. You want to attempt to connect to the network share.
You receive the following error message, ‘the network location cannot be reached? You run IP configure
to view the configuration on client 2. Which configuration setting would you change?
 

Please translate into german before solving the situation :-)

Answer:
Explanation:... to be continued ...

 

3. Situation

You install Windows 2000 Professional on a computer named Client2. The computer
is configured to have a TCP/IP address of 10.10.167.4 and a default gateway of 10.10.167.1
You want to connect to a shared folder on a server B. When you attempt to connect to
the network share you receive the following error message, ‘the network location could
not be reached?
You run IP config to review the configuration as shown in IP configuration exhibit.
 

You want to allow Client2 to connect to server B. What should you do?

A. Place Client2 on the same segment as server B.
B. Place a computer running the wins proxy server on the same segment as Client2.
C. Configure Client2 to use a default gateway of 10.10.13.1.
D. Configure Client2 use a DNS server address 10.10.13.24.
E. Configure Client2 to use a WINS server address of 10.10.13.24.

Please translate into german before solving the situation :-)

Answer:
Explanation:... to be continued ...